AIRLUX YPH-12H-S1 Manuel d'utilisateur télécharger pdf (Page 15)

- - 14 - -

MAINTENANCE

Cleaning

Turn off the unit and pull the plug out of the socket before cleaning.

1. Clean the surface

Clean the surface of the unit with a duster or a half-wet soft cloth.

Do not use chemical solvent like benzene, alcohol, gasoline, etc.,

otherwise the surface may be damaged or even deformed.

2. Clean the air filter

If the air filter is blocked with a lot of dust,

the efficiency will be reduced. You’d better

Clean the filter every two weeks.

1) Pull out the air filter as Fig.15.

2) Wash the air filter by immersing it

gently into warm(under 40°C or 104°F)

water with neutral detergent. Rinse the

filter and dry it in a shaded place.

2) Push the air filter back into the original

position.

End of season

1. Pull the plug out of the drain mouth and remove the water from

the water plate and inner water tank. You can remove the water

entirely by slanting the unit back.

Setting the fan mode, then press the Fan button for 5 seconds until

the lower fan works. After that, operate the unit in fan mode for 2 to

3 hours until the pipe is dry. In this way the inside of the unit can be

dried and the mildew growth can be suppressed.

2. Switch off the unit and disconnect the plug from the power

supply.

3. Tie the cable with sting.

4. Remove the air exhaust duct and keep it carefully.

5. Wrap the unit with the plastic bag, and keep it in a dry place.

6. Take the batteries out of the remote control and keep them well.

Fig 15

1 2 ... 10 11 12 13 14 15 16 17 18

Pas de commentaire

AIRLUX YPH-12H-S1 Manuel d'utilisateur Page 15