AIRLUX YPH-12H-S1 Manuel d'utilisateur télécharger pdf (Page 14)

- - 13 - -

Adding and Draining Water

Adding water

＊The condensing water is recycled to improve efficiency through

cooling condenser. Also it will lower the noise and save energy.

＊When the condensing water is not enough for pumping, the water

Injection indicator on the control panel will illuminate, you’d better

inject some water into the water draw, right of the handle, there is

a cover. Meanwhile, pay attention the water level pole at your

right, where show the water quantity.

Note: The water-cool-mode is not working under

dehumidifying, fan or heating mode. Do not add water.

Drainage

＊When the water is full, the water full indicator will light and the

compressor will stop working. The buzzer will buzz 10 times every

5 minutes until the water is below the high level or drained by hand.

When the alarm stops the unit will work automatically.

＊Before you drain the water you need to turn the unit off and pull

the plug out of the power supply. Upcap the lid, remove the rubber

plug on the drainage port, then let the water flow out. Once drained,

put the rubber plug back and screw the lid up an switch it on.

(Fig.14). If the provided pipe is not long enough, you may buy a

longer one (inner diameters 9mn).

Note

Move the unit gently when the water is high. If not, the water may

spill all inside of the unit.

Plug

Drainage Port

Cover

Lid

Fig 13

Water Draw

Clean Water

Water Level

Small Cover

1 2 ... 9 10 11 12 13 14 15 16 17 18

Pas de commentaire

AIRLUX YPH-12H-S1 Manuel d'utilisateur Page 14